Use starter parts and labor matrices
Elite and Ultra plansReview the starter parts matrix and flat labor default, adjust tiers, and use the Example column before saving.
Last reviewed October 15, 2026
A matrix applies a multiplier to your shop's own part cost or labor rate. New shops start with the ShopRally starter parts matrix and Flat ×1 (default) for labor. Set your shop's hourly labor rate separately in Labor rates.
Steps
- Open Shop Settings › Markups › Parts matrix (opens in a new tab). Click Configure beside the matrix you want to review.
- Check each tier's Cost from ($) and Cost to ($). Adjust its Multiplier, Gross profit % or Markup %; the other pricing columns update to agree.
- Read the Example column for the tier's calculated result. While you edit, it says Example (if saved). It is a preview and adds nothing to an estimate.
- If you want to reload the parts starting point, click Reset to ShopRally starter, then Load starter into draft.
- Review your parts tiers and click Save parts matrix to apply them.
- Open Labor matrix (opens in a new tab). Check Hours from, Hours to, Multiplier and Markup %. Its examples use your shop's default labor rate.
- To load the optional tiered labor setup, click Reset to ShopRally Standard, then Load ShopRally Standard into draft. To return to the flat default, click Use flat ×1 (default), then Load flat ×1 into draft.
- Review your changes and click Save labor matrix. A reset loads a draft; the Save result confirms whether it was applied.
What to know
- Flat ×1 prices labor as hours times your own labor rate. ShopRally Standard changes the multiplier by the hours range; it keeps the hours themselves unchanged. Labor hours come from Mitchell.
- Parts use cost ranges. Every cost needs a range; leave the final Cost to ($) blank for no maximum. Fix any coverage warning shown before saving.
- A part type with no named matrix assigned uses your default parts matrix. Lines already on estimates keep their prices after a matrix change.
- Labor examples show a dash until your shop has a usable rate. Set your labor rate first.
- You need money settings access to change matrices.